UHF Female LMR 200 Crimp

•  Prepare the Cable:
  – Strip the Outer Jacket: Use a cable stripping tool to remove about 1.5 to 2 inches of the outer jacket from the LMR 200 cable. Be careful not to damage the braided shield underneath.
  – Expose the Shielding: Pull back the braided shield. You may need to trim any excess shield to ensure it doesn’t interfere with the crimping process.
  – Strip the Dielectric: Strip the dielectric insulation to expose the center conductor. The length of exposed center conductor should be about 1/4 to 1/2 inch.
• Prepare the Connector:
  – Slide the Ferrule: Before attaching the connector parts, slide the metal ferrule (sleeve) onto the cable. This ferrule will be crimped onto the braided shield later.
  –Insert the Cable into the Connector : Insert the prepared end of the cable into the UHF female connector. The center conductor should fit into the center pin of the connector, and the shield should align with the ferrule.
• Crimp the Connector:

– Crimp the Ferrule: Use the crimping tool to crimp the ferrule onto the braided shield of the cable. Ensure the crimp is tight and secure, making a solid connection between the shield and the connector.
– Crimp the Center Pin: Next, crimp the center pin of the connector onto the center conductor of the cable. Make sure the conductor is properly inserted into the pin before crimping.

• Assemble and Insulate (Optional):
  – Check the Fit: Verify that the connector is firmly attached and that there are no loose parts. Ensure the center pin is well-aligned, and the shield is securely crimped.
  – Heat Shrink Tubing: If you’re using heat shrink tubing for additional insulation and strain relief, slide it over the joint and apply heat to shrink it.
• Inspect the Assembly:
  – Verify Connections: Inspect the solder joints and the crimped areas to ensure they are clean and well-formed.
  – Test the Connection: Optionally, test the assembled connector for continuity and signal integrity to ensure proper operation.